Parameters
priority Enter a number as the priority. Enter 255 only if the router’s
virtual address is the same as the interface’s primary IP
address (that is, the router is the OWNER). The range is from
1 to 255. The default is 100.
Defaults 100
Command
Modes
VRRP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.16.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage
Information
To guarantee that a VRRP group becomes MASTER, configure the VRRP group’s
virtual address with same IP address as the interface’s primary IP address and
change the priority of the VRRP group to 255.
If you set the priority command to 255 and the virtual-address is not equal
to the interface’s primary IP address, an error message appears.
show config
View the non-default VRRP configuration.
Z9500
Syntax
show config [verbose]
Parameters
verbose (OPTIONAL) Enter the keyword verbose to view all VRRP
group configuration information, including defaults.
Command
Modes
VRRP
1890
Virtual Router Redundancy Protocol (VRRP)
