Usage
Information
This command creates a crypto policy entry and enters the crypto policy
configuration mode for configuring the flow parameters.
Example
Dell(conf)#crypto ipsec policy West 10 ipsec-manual
Dell(conf-crypto-policy)#
management crypto-policy
Apply the crypto policy to management traffic.
Z9500
Syntax
management crypto-policy name
To remove the management traffic crypto policy, use the no management
crypto-policy
name command.
Parameters
name Enter the name for the crypto policy..
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the Z9000, S4810, and S4820T.
match
Apply an match filter to the crypto policy.
Z9500
Syntax
match seq-num tcp [sourceip address | ipv6 address {mask}
{source-port number}] [destination ip address | ipv6 address
{mask} {destination-port number}]
918
Internet Protocol Security (IPSec)
