peer-group-
name
Enter the name of the peer group.
prefix-list-
name
Enter the name of an established prefix list. If you do not
configure the prefix list, the default is permit (to allow all
routes).
in Enter the keyword in to distribute only inbound traffic.
out Enter the keyword out to distribute only outbound traffic.
Defaults Not configured.
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Usage
Information
Other BGP filtering commands include the neighbor filter-list and
neighbor route-map commands.
Related
Commands
• neighbor filter-list – assigns a AS-PATH list to a neighbor or peer group.
• neighbor route-map – assigns a route map to a neighbor or peer group.
neighbor ebgp-multihop
Attempt and accept BGP connections to external peers on networks that are not directly connected.
Z9500
Syntax
neighbor {ipv6-address | peer-group-name} ebgp-multihop [ttl]
To disallow and disconnect connections, use the no neighbor {ipv6-address
| peer-group-name} ebgp-multihop [ttl] command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
Enter the name of the peer group.
ttl (OPTIONAL) Enter the number of hops as the time to live (ttl)
value. The range is 1 to 255. The default is 255.
Border Gateway Protocol
541
