Version Description
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the Z9000, S4810, and S4820T.
Usage
Information
• Both sides of the link must specify the same transform set.
• You can create up to 64 transform sets.
Example
Dell(conf)#int ten 0/4
Dell(conf-if-te-0/4)#ipv6 address 200:1::/64 eui64
Dell(conf)#int ten 0/6
Dell(conf-if-te-0/6)#ipv6 address 801:10::/64 eui64
crypto ipsec policy
Create a crypto policy used by ipsec.
Z9500
Syntax
crypto ipsec policy name seq-num ipsec-manual
To delete a crypto policy entry, use the no crypto ipsec policy name seq-
num
ipsec-manual command.
Parameters
name Enter the name for the crypto policy set.
seq-num Enter the sequence number assigned to the crypto policy
entry.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the Z9000, S4810, and S4820T.
Internet Protocol Security (IPSec)
917
