rate-limit
Configure the rate-limit to limit the mirrored packets.
Syntax
rate-limit limit
To remove the limit, use the no rate-limit limit command.
Parameters
limit Enter the rate-limit value. The range is from 0 to 40000
Megabits per second.
Defaults 60
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000-
ON, Z9500.
Related
Commands
monitor session — enables a monitoring session.
show monitor session — displays the monitor session.
show config
Display the current monitor session configuration.
Z9500
Syntax
show config
Defaults none
Command
Modes
MONITOR SESSION (conf-mon-sess-session-ID)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Port Monitoring
1439
