vrrp bfd
Establish a BFD session with VRRP neighbors.
Z9500
Syntax
vrrp bfd {all-neighbors | neighbor ip-address} [interval
interval min_rx min_rx multiplier value role {active |
passive}]
To undo your VRRP BFD configuration, use the no vrrp bfd {all-neighbors
| neighbor ip-address } [interval interval min_rx min_rx
multiplier value role {active | passive}] command.
Parameters
all-neighbors Establish BFD sessions with all BFD neighbors on an
interface.
neighbor ip-
address
Enter the IP address of the BFD neighbor.
interval
milliseconds
(OPTIONAL) Enter the keyword interval to specify non-
default BFD session parameters beginning with the
transmission interval. The range is 50 to 1000. The default is
100.
min_rx
milliseconds
Enter the keyword min_rx to specify the minimum rate at
which the local system would like to receive control packets
from the remote system. The range is 50 to 1000. The
default is
100.
multiplier Enter the keyword multiplier to specify the number of
packets that must be missed in order to declare a session
down. The range is 3 to 50. The default is 3.
role [active |
passive]
Enter the role that the local system assumes:
• Active—The active system initiates the BFD session.
Both systems can be active for the same session.
• Passive—The passive system does not initiate a session.
It only responds to a request for session initialization
from the active system.
The default is Active.
Defaults See Parameters.
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
358
Bidirectional Forwarding Detection (BFD)
