Version Description
9.2(1.0) Introduced on the Z9500.
8.4.1.0 Added support for IPv4 multicast and IPv4 unicast address
families.
8.3.19.0 Introduced on the S4820T.
7.8.1.0 Introduced on the S4810.
7.7.1.0 Introduced on the C-Series.
7.4.1.0 Introduced
Usage
Information
This command enables soft-reconfiguration for the specified BGP neighbor. BGP
stores all updates for inbound IPv6 unicast routes the neighbor receives but does
not reset the peer-session.
CAUTION: Inbound update storage is a memory-intensive operation. The
entire BGP update database from the neighbor is stored in memory
regardless of the inbound policy results applied on the neighbor.
neighbor subnet
Enable passive peering so that the members of the peer group are dynamic.
Z9500
Syntax
neighbor peer-group-name subnet subnet-number mask
To remove passive peering, use the no neighbor peer-group-name subnet
subnet-number mask command.
Parameters
subnet-number Enter a subnet number in dotted decimal format (A.B.C.D.) as
the allowable range of addresses included in the peer group.
To allow all addresses, enter 0::0/0.
mask Enter a prefix mask in / prefix-length format (/x).
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
Version Description
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Border Gateway Protocol
553
