operator (OPTIONAL) For the TCP and UDP parameters only. Enter
one of the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt= less than
• range = inclusive range of ports (you must specify two
ports for the port command parameter.)
source port Enter the keywords source-port then the port number to
be matched in the ACL rule in the ICAP rule
destination-
port
Enter the keywords destination-port then the port
number to be matched in the ACL rule in the ICAP rule.
source-port-
range
Enter the keywords Source-port-range then the range of
the start port to end port to be matched in the ACL rule in
the ICAP rule.
destination-
port-range
Enter the keywords destination-port-range then the
range of the start port to end port to be matched in the ACL
rule in the ICAP rule.
Defaults none
Command
Modes
REDIRECT-LIST
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added the keyword track-id on the Z9500.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
Policy-based Routing (PBR)
1431
