Version Description
9.7(0.0) Introduced on the S4810, S4820T, S6000 and Z-Series.
ip dhcp snooping vlan
Enable DHCP Snooping on one or more VLANs.
Z9500
Syntax
[no] ip dhcp snooping vlan name
Parameters
name Enter the name of a VLAN on which to enable DHCP
Snooping.
Defaults Disabled
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.11.1 Introduced on the Z9000.
8.3.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series and S-Series.
Usage
Information
When enabled, the system begins creating entries in the binding table for the
specified VLANs.
NOTE: Learning only happens if there is a trusted port in the VLAN.
Related
Commands
ip dhcp snooping trust — configures an interface as trusted.
ipv6 dhcp snooping vlan
Enable ipv6 DHCP Snooping on VLAN or range of VLANs.
Syntax
[no] ip dhcp snooping vlan vlan-id
To disable the ipv6 dhcp snooping on VLAN basis or range of VLAN, use the no
ipv6 dhcp snooping vlan <vlan-id> command.
Dynamic Host Configuration Protocol (DHCP)
733
