IES-1000 User’s Guide
20-4 Diagnostics
Table 20-3 Log Messages
LOG MESSAGE TYPE DESCRIPTION
GSHDSL <port> Link
Info: NM=<noise
margin> ATT=<loop
attenuation>
INFO
This log displays information about a G.SHDSL port’s connection.
<port> - port number
<noise margin> - the connection’s signal quality in dB.
<loop attenuation> - the connection’s line loss in dB.
GSHDSL <port> Link
Up(SN=<seq no>):
rate=<rate>Kbps
WARN
A G.SHDSL port established a connection.
<seq no> - sequence number of the connection
<rate> - the connection’s rate
GSHDSL <port> Link
Down(SN=<seq no>)
NM=<noise margin>
ATT=<loop attenuation>
WARN
A G.SHDSL port lost its connection.
GSHDSL <port> CRC
crcAnomaly:<couter1>
LOSW Defect:<couter2>
LOSW Failure:<couter3>
WARN
These are G.SHDSL port error counters.
<couter1>- the number of cyclic redundancy check errors
<couter2> - the number of Loss of Sync Word defects
<couter3> - the number of Loss of Sync Word failures
GSHDSL <port> ATT
Defect:<couter1> SNR
Defect:<couter2>
WARN
These are G.SHDSL port error counters.
<couter1> - the number of times the loop attenuation was too
high
<couter2> - SNR (Signal to Noise Ratio) the number of times the
signal quality was too low.
HTTPD data crash
theAllegroServerDataPt
r <mem addr>
ERROR
The network module failed in an attempt to construct an HTTP (web
configurator) session.
File too large <file
id> <file size>
WARN
The file size was too large with an attempted HTTP (web
configurator) firmware upload.
Insecure HTTP From <ip
addr>
WARN
Someone tried to start an HTTP (web configurator) session from the
listed IP address and it did not match any of the configured secured
client IP addresses.
Watchdog timeout WARN
The hardware watchdog determined that the network module was
hung or not executing the correct sequence of code and restarted the
network module.
Warm Start Trap WARN
The network module restarted as a result of a reboot command.
Cold Start Trap WARN
The network module started.
Core Dump!!! WARN
The error log is not kept after a restart. When the network module
restarts due to a software level error, you can use config save in
order to create a core file. Send the core file to customer support for
analysis.
THERMO OVER RANGE:
dev:<device id>
value:<temp>
WARN
The temperature detected in the network module was too high.
<temp> - temperature when the entry was logged
