ZyXEL Communications IES-1000 Manual

A SERVICE OF

next previous

IES-1000 User’s Guide

Removing and Installing Network Modules 5-1

This chapter shows you how to remove and install network modules.

Each IES-1000 accommodates up to two network modules. Remove and install modules via the front of the IES-

1000. The figure below shows the front view of a SAM1008 network module; the procedures for removing and

installing AAM1008 network modules are the same.

Figure 5-1 IES-1000 G.SHDSL SAM1008 Network Module

5.1 Removing a G.SHDSL SAM1008 Network Module

Step 1. Loosen the two screws on the front panel that secure the module to the chassis by turning them counter-

clockwise as shown next.

Figure 5-2 Loosen Module Screws

Step 2. Gently pull the network module out of the chassis as shown next.

Chapter 5

Removing

and Installing Network Modules