IES-1000 User’s Guide
10-10 Getting Started Screens
Table 10-8 Bridge MAC Filter Entry Add
LABEL DESCRIPTION
Apply Click Apply to save your changes back to the IES-1000's volatile memory. The IES-1000
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel to the left to save your changes to the non-volatile memory when you are
done configuring.
Reset Click Reset to begin configuring this screen afresh.
10.5.3 MAC Count Filter Setup Screen
Click MAC Count Filter in the Bridge Setup screen to open this screen.
Use this screen to limit the number of MAC addresses that may be dynamically learned or statically configured on
a DSL port.
Figure 10-10 MAC Count Filter Setup
The following table describes the labels in this screen.
Table 10-9 MAC Count Filter Setup
LABEL DESCRIPTION
Bridge Setup Click this link to go to the Bridge Setup screen.
Port Number This field displays a DSL port number. Click an entry to go to a screen to edit the number of
MAC addresses that may be learned on that port.
Filtering Enable? This field tells whether or not MAC address count filtering has been enabled for that port.
Max Dynamic
MAC Count
This field’s first number displays how many dynamically learned MAC addresses are recorded
for a port.
This field’s second number displays the limit of how many MAC addresses may be dynamically
learned on the port.
