A SERVICE OF

logo

Open as PDF
next previous
IES-1000 User’s Guide
Hardware Connections 6-1
This chapter shows you how and where to make hardware connections.
Before you make your hardware connections, make sure that your IES-1000 is safely and securely positioned.
6.1 Front Panel Connections
All connections are made on the front panel of the IES-1000. The following figure shows the front panel
connections of the SAM1008. Connect A to a power source. B is an Ethernet switch. Connect C to the users. D is
a local management computer. A more detailed discussion follows. Connections for the AAM1008 are the same
except for the DSL ports (see 6.4 for details).
Figure 6-1 SAM1008 Front Panel Connections Overview
6.2 Console Port
For the initial configuration, you need to use terminal emulator software on a computer and connect it to a network
module through the console port. Connect the mini-RJ-11 end of the console cable to the console port of the
network module. Connect the other end to a serial port of your computer. After the initial setup, you can modify
the configuration remotely through Telnet connections.
Chapter 6
Hardware
Connections