IES-1000 User’s Guide
22-12 Commands Introduction
Table 22-1 Commands
MODULE COMMAND DESCRIPTION
loopback
<portNo> local | f5
Does a local/OAM F5 loopback test on
the specified GSHDSL port.
stat
ch <port> <vpi> <vci>
Shows the statistics of the specified
PVC channel.
chs [<start port> [<end port>]]
Shows the statistics of all PVC
channels in all ports or in the specified
port.
clear
ch <port> <vpi> <vci>
Clears the statistics of the specified
PVC channel.
chs [<start port> [<end port>]]
Clears the statistics of all PVC
channels in all ports or in the specified
port.
gshdsl
The gshdsl commands apply to the
SAM module.
config save
Saves configuration of GSHDSL
module to nonvolatile memory.
enable
ch <port> <vpi> <vci>
Enables the specified PVC channel(s).
chs [<start port> [<stop
port>]]
Enables all PVC channels for specific
ports.
Enables the specified GSHDSL port.
ports
Enables all GSHDSL ports.
disable
ch <port> <vpi> <vci>
Disables the specified PVC
channel(s).
chs [<start port> [<stop
port>]]
Disables all PVC channels for the
specified ports.
Disables the specified GSHDSL port.
ports
Disables all GSHDSL ports.
Shows the statistics of the specified
GSHDSL ports.
Shows the line quality of the specified
GSHDSL port.
set
ch <port> <vpi> <vci> <pvid>
<priority> <vcp name>
Creates a new PVC channel, or
modifies an existing one.
ch <port> <vpi> <vci> super
<vcp name>
Creates a super channel, or modifies
an existing one.
profile <profile name> <Cmax>
[<Cmin>] [annexA | annexB]
Sets the specified profile a maximum
and a minimum rate, and a PSD
region.
Applies a specified profile setting to a
GSHDSL port.
Applies the specified profile setting to
all GSHDSL ports.
