IES-1000 User’s Guide
25-4 G.SHDSL Commands
where
<Port> =
The port number on the SAM1008.
<Sp> =
The line rate. If Sp=0, then the connection is down.
<NM> =
Noise Margin. The noise margin in decibels.
<ATTEN> =
Attenuation. The loop attenuation in decibels.
<ES> =
Errored Second. The total number of one-second intervals when one or more CRC
errors are found.
<SES> =
Severely Errored Second. The total number of one-second intervals when at least fifty
CRC errors are found.
<LOSWS> =
Loss of Sync Word Failure Second. Displays the total number of one-second intervals
when one or more SHDSL LOSW errors are found.
<UAS> =
Unavailable Second. The total number of one-second intervals when the G.SHDSL
line is unavailable.
<downN> =
The number of times the G.SHDSL line has been dropped.
25.3.8 List Port Command
Syntax:
192.168.1.1 gshdsl> list port <port #>
where
<port #> =
The port number, from 1 to 8
This command displays information about the line speed, state and the line rate parameter of a G.SHDSL port.
An example is shown next.
Figure 25-1 List Port Command Example
where
Cmax =
Configured maximum line speed in Kbps. The maximum G.SHDSL line speed you
configured. For details about configuring this parameter see section 25.3.15.
Cmin =
This is the configured minimum line speed in Kbps for this port. The minimum
G.SHDSL line speed you configured.
Act =
The actual G.SHDSL line speed in Kbps.
192.168.1.1 gshdsl> list port 8
Port Speed (Kbps) Mode Bonding PSD region State
Cmax/Cmin/Act
----+---------------+---------------+--------+-----------+--------------
1 2304/ 192/ - Normal No annexB Disabled/Down
2 2304/ 192/ - 2-wireC Yes annexB Disabled/Down
3 2304/ 192/ - 2-wireC Yes annexB Disabled/Down
4 2304/ 192/ - 2-wireC Yes annexB Disabled/Down
5 2304/ 192/ - Normal No annexB Disabled/Down
6 2304/ 192/ - Normal No annexB Disabled/Down
7 2304/ 192/ - Normal No annexB Disabled/Down
8 2304/ 192/ - 2-wireC Yes annexB Disabled/Down
