IES-1000 User’s Guide
22-6 Commands Introduction
Table 22-1 Commands
MODULE COMMAND DESCRIPTION
Reads the MII register of the device
with the selected PHY address.
Writes data to the MII register of the
device with selected the PHY address.
chips
cpu
Shows CPU usage.
debug
Starts debug mode (ATMOS).
exit
Exits the debugger (ATMOS).
info
Shows version information and MAC
address.
mem
Shows memory usage on a per-
process basis.
stack
Shows stack usage on a per-process
basis.
Reads 1 byte from the specified
address.
Reads 1 half-word from the specified
address.
Reads 1 word from the specified
address.
Writes 1 byte to the specified address.
Writes 1 half-word to the specified
address.
Writes 1 word to the specified address.
tell
<process> <cmd> [<attrs>]
Sends a tell command to the specified
process.
config
list
Displays all registered modules.
print
Shows configuration information for all
modules.
<module>
Shows configuration information for
the specified module.
reset
Resets configuration information in all
modules from nonvolatile memory.
<module>
Resets configuration information in the
specified module from nonvolatile
memory.
save
Saves configuration information in all
modules to nonvolatile memory.
resource
Shows the controlled resources in all
processes.
