IES-1000 User’s Guide
10-12 Getting Started Screens
Table 10-10 MAC Count Filter Edit
LABEL DESCRIPTION
Max Static MAC
Count
Use this field to limit the number of MAC addresses that may be statically specified for this port.
For example, if you are configuring port 2 and you set this field to "5", then only five device
MAC addresses may be statically configured on port 2 at any one time.
The valid range is from “0” to “5”. “0” means no MAC addresses may be statically specified for
this port.
Apply Click Apply to save your changes back to the IES-1000's volatile memory. The IES-1000 loses
these changes if it is turned off or loses power, so use the Config Save link on the navigation
panel to the left to save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to begin configuring this screen afresh.
10.5.5 Bridge MAC Address Record Screen
Click MAC Address Record in the Bridge Setup screen to open this screen.
This screen displays a list of the MAC addresses that have connected to each individual port on the network
module. The listing includes MAC addresses and the connected time (measured in seconds) for each port.
Figure 10-12 Bridge MAC Address Record
