IES-1000 User’s Guide
24-8 ADSL Commands
An example is shown next.
Figure 24-4 Linerate Command Example
These results contain the current downstream and upstream operating values (SHOWTIME) for the requested line,
the latest available downstream and upstream margins, channel attenuation and the maximum attainable rate.
Downstream and upstream margins must both be at least 6 dB. The initial downstream and upstream margins are
first set during training. The upstream margin is recalculated every 15 seconds during “show time” at the ATU-C
and the downstream margin updates every 15 seconds during “show time” by using EOC messaging.
Information obtained prior to training to steady state transition will not be valid or will be old information.
24.3.10 Line Delay Command
Syntax:
192.168.1.1 adsl>
ldly <ports|port number> [<downstream value> <upstream
value> <Symbol|MilliSec>]
where
<
ports|port number > =
All of the ADSL ports or a single port, from 1 to 8.
<downstream value> =
The downstream interleave latency delay (0..255)
<upstream value> =
The upstream interleave latency delay (0..255) milliseconds.
<Symbol|MilliSec>] =
Set the measurement of the interleave delay to use with symbols or
milliseconds.
Sets or displays the maximum interleave latency delay.
24.3.11 List Port Command
Syntax:
192.168.1.1 adsl> list port <port number>
where
<port number> = A port number, from 1 to 8.
The list port command shows the configured maximum upstream/downstream rates, the mode (or standard),
and enable/disable state of an individual ADSL port.
192.168.1.1 adsl> linerate 7
Current Active Rates:
AS0 downstream rate : 2048 Kbps
AS1 downstream rate : 0 Kbps
LS0 upstream rate : 512 Kbps
LS1 upstream rate : 0 Kbps
Down/up stream Margin : 31/22 dB
Down/up stream Attenuation : 0/ 0 dB
Attainable Down/up stream Rate : 11456/ 1344 Kbps
