IES-1000 User’s Guide
28-2 Bridge Commands
192.168.1.1 bridge> status
This command displays the bridge management statistics.
28.4 MAC Filter Commands
Use MAC filter commands to filter incoming frames based on MAC (Media Access Control) address(es) that you
specify. If you do not use this command, your IES-1000 will not filter frames. MAC filter commands are listed
next. You may specify up to five MAC addresses per port.
28.4.1 MAC Filter Command
Syntax:
192.168.1.1 bridge> macfilter [<port>]
where
port =
A bridge port number.
This command displays the MAC filtering status and the fixed source MAC addresses on a port or on all ports
if no port is specified.
28.4.2 MAC Filter Enable Command
Syntax:
192.168.1.1 bridge> macfilter enable [<port>]
where
<port> =
A bridge port number.
This command enables the MAC filtering feature on a specific port or on all ports if no port is specified.
28.4.3 MAC Filter Disable Command
Syntax:
192.168.1.1 bridge> macfilter disable [<port>]
where
<port> =
A bridge port number.
This command disables the MAC filtering feature on a specific port or on all ports if no port is specified.
28.4.4 MAC Filter Add Command
Syntax:
192.168.1.1 bridge> macfilter add <port> <mac>
where
