Event log message Description Comments
13.02.00 Jam inside the top cover
●
For jam location information, see
Jam locations on page 220.
●
If the error persists, a sensor might
be damaged. See
Paper-path test
(and automatic sensors test)
on page 136 or Sensor test
(interactive) on page 137.
13.98.00 Paper jam open input trays
●
For jam location information, see
Jam locations on page 220.
●
If the error persists, a sensor might
be damaged. See
Paper-path test
(and automatic sensors test)
on page 136 or Sensor test
(interactive) on page 137.
14.X Feed roller error
54.01 The humidity-environment sensor (TH3)
is abnormal.
1. Make sure that the product is in an
environment that meets the
specifications in
Environmental
specifications on page 309.
2. Make sure that connector J1803 is
fulley seated on the ECU.
3. If the error persists, replace the
environment sensor. See
Main fan,
fan duct, and environmental sensor
on page 98.
55 901C DCC restored DCC NVRAM was restored from the
formatter.
68 8X04 The permanent storage date does not
match the engine.
68 8X05 The permanent storage date does match
the engine.
73.00.00 Printer error Power cycle the product.
8x7345 Disk clean successful X denotes the slot number (0 is internal).
8x7346 Disk clean failed A hard disk or compact flash disk
cleaning failed. Usually caused by a
hardware failure of the disk. X denotes
the slot number.
8x7347 Some of the sanitized disk did not
correctly verify.
88.00.XX FailCode from engine self-test execution.
Table 3-8 Event log only messages (continued)
218 Chapter 3 Solve problems ENWW
